Good morning everyone,
I am writing to get other opinions on this subject:
I have installed the FlyMotion electronics controlled by Mach3, I configured the parameters given to me in the manual, the motion part consists of a Nema 34 12 nm motor with a 1000 resolution encoder, the ACME screw motor connection is via a two piece pulley, the screw moves in pitch, I tried the axis connection first then the free motor because I thought it was a problem of undersized motors, but at this point all three motors are broken, probably the driver too, the only problem is the polarity of the connector, so I wonder how to find that on the engine? The wiring diagram for the motor shows the pins but not the wire colors.
Motor and driver: https://www.oyostepper.com/goods-468-1- ... river.html
Welcome to Synthesizer New Zealand, don't forget to register here! Note: This notification disappears after registration.